Anet A8 Power Supply Cover

1 16 of 507 results for anet a8 power supply etopxizu 12v 30a dc universal regulated switching power supply 360w for cctv radio computer project.

Anet a8 power supply cover.

The bracket converts from the original screw layout to the new screw layout. Get it as soon as sat sep 19. This cover and bracket is for a newstyle 360w power supply or similar. Anet a8 power supply cover with iec320 c14 socket space by ismaelpr1 thingiverse.

Than i addedd a 5 8mm hole for a lever switch i use for a 120mm fan on the power supply but you can also use it for leds or something else. Remixed with tinkercad here is the switch i used. Adding a mains socket to the anet a8 power supply the anet a8 is powered from the mains. I ve seen advice from multiple people that a 500 watt power supply is required yet the supplied powersupply is rated for 21a so it can only be 252w.

To install the bracket first you will need to place four m3 washers in the location of the old screws. This is perfect for that. The mains connector switch assembly is now fitted into the power supply connector cover. Unable to load your thing at the moment.

I removed the text and the holes for the ac plug and switch because the one i have is a little bit different. Anet a8 power supply cover with switch by cyberlamb thingiverse. Yo recently put together an anet a8 and i m looking to address the power supply concerns with a new atx power supply and mosfets but some of the info on doing this seems a little confusing. The two screws are fitted and the correct nuts are secured on the back.

I secured them with a small piece of tape so. I wanted a beefier power supply to improve bed and nozzle warm up times. 4 4 out of 5 stars 1 291.